[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: A quick question on http://www.ietf.org/internet-drafts/draft-ietf-ccamp-gmpls-recovery-e2e-signaling-03.txt




zafar, i am not sure to fully understand your question

the O-bit is used for 1+1 and 1:1 protection scheme such as to have an indication when a protecting LSP is carrying the "normal" traffic after protection switching (so it applies only in case of 1+1 LSP uni-/bidirectional protection or 1:1 LSP protection)

thanks,
- dimitri.

ps: purpose is not to "contrast" between protection schemes



"Zafar Ali \(zali\)" <zali@cisco.com>
Sent by: owner-ccamp@ops.ietf.org

19/12/2005 23:10

       
        To:        <ccamp@ops.ietf.org>
        cc:        "Adrian Farrel" <adrian@olddog.co.uk>, Dimitri PAPADIMITRIOU/BE/ALCATEL@ALCATEL
        Subject:        A quick question on http://www.ietf.org/internet-drafts/draft-ietf-ccamp-gmpls-recovery-e2e-signaling-03.txt



Hi All,
 
It's a bit confusing how one would encode protection object for dedicated 1:1 protection (without traffic duplication) and I thought it deserves a confirmation.
 
I just wanted to confirm that to signal an LSP that is dedicated 1:1 protection, where we are expected to: If above is not the intended use of O-bit, I am not sure why O-bit is defined (as protection LSP is expected to carry normal traffic after switchover). In which is it expected to use 0x04 = 1:N Protection with Extra-Traffic as LSP (Protection Type) Flags?
 
Thanks
 
Regards... Zafar