Re: Diameter QoSFilterRule AVP

[Bernard Aboba <aboba@internaut.com>]

> How do you want to represent QoS attributes for each kind of media?

Diameter has the QoSFilterRule AVP, defined in RFC 3588, Section 4.3.  Has
anyone analyzed the capabilities that are supported there?  Here's what
RFC 3588 says about it:

QoSFilterRule filters MUST follow the format:

   action dir proto from src to dst [options]

   action
                tag    - Mark packet with a specific DSCP
                         [DIFFSERV].  The DSCP option MUST be
                         included.
                meter  - Meter traffic.  The metering options
                         MUST be included.

   dir      The format is as described under IPFilterRule.

   proto    The format is as described under IPFilterRule.

   src and dst  The format is as described under IPFilterRule.

   options:
            frag    Match if the packet is a fragment and this is not
                    the first fragment of the datagram.  frag may not
                    be used in conjunction with either tcpflags or
                    TCP/UDP port specifications.

            ipoptions spec
                    Match if the IP header contains the comma
                    separated list of options specified in spec.  The
                    supported IP options are:

                    ssrr (strict source route), lsrr (loose source
                    route), rr (record packet route) and ts
                    (timestamp).  The absence of a particular option
                    may be denoted with a '!'.

            tcpoptions spec
                    Match if the TCP header contains the comma
                    separated list of options specified in spec.  The
                    supported TCP options are:

                    mss (maximum segment size), window (tcp window
                    advertisement), sack (selective ack), ts (rfc1323
                    timestamp) and cc (rfc1644 t/tcp connection
                    count).  The absence of a particular option may
                    be denoted with a '!'.

            established
                    TCP packets only.  Match packets that have the RST
                    or ACK bits set.

            setup   TCP packets only.  Match packets that have the SYN
                    bit set but no ACK bit.

            tcpflags spec
                    TCP packets only.  Match if the TCP header
                    contains the comma separated list of flags
                    specified in spec.  The supported TCP flags are:

                    fin, syn, rst, psh, ack and urg.  The absence of a
                    particular flag may be denoted with a '!'.  A rule
                    that contains a tcpflags specification can never
                    match a fragmented packet that has a non-zero
                    offset.  See the frag option for details on
                    matching fragmented packets.

            icmptypes types
                    ICMP packets only.  Match if the ICMP type is in
                    the list types.  The list may be specified as any
                    combination of ranges or individual types
                    separated by commas.  Both the numeric values and
                    the symbolic values listed below can be used.  The
                    supported ICMP types are:

                    echo reply (0), destination unreachable (3),
                    source quench (4), redirect (5), echo request
                    (8), router advertisement (9), router
                    solicitation (10), time-to-live exceeded (11), IP
                    header bad (12), timestamp request (13),
                    timestamp reply (14), information request (15),
                    information reply (16), address mask request (17)
                    and address mask reply (18).



--
to unsubscribe send a message to radiusext-request@ops.ietf.org with
the word 'unsubscribe' in a single line as the message text body.
archive: <http://psg.com/lists/radiusext/>