I-D: Simple Configured Tunnel Setup Procedure

[Pekka Savola <pekkas@netcore.fi>]

Hi,

Based on the "simplified ISATAP" discussions and prior to that, my
desire to show that setting up configured tunnels in the 3GPP scenario
can be pretty simple, I banged the keyboard a bit and produced a
"proof-of-concept" draft:

     A Simple IPv6-in-IPv4 Configured Tunnel Set-Up Procedure

Abstract

   This memo describes a set of operational procedures and one
   implementation mechanism to provide a very simple and straightforward
   way to easily manage IPv6-over-IPv4 configured tunnels between an ISP
   and a customer.  The configured tunnels work even if the IPv4
   addresses change dynamically, or are private addresses; the procedure
   provides at least a /64 prefix per customer and requires no
   administrative set-up.  Support for NAT Traversal is currently out of
   scope.

I just sent it to the I-D repository, so in the meantime, it's 
available (less than 10 pages of content) at:

http://www.netcore.fi/pekkas/ietf/draft-savola-v6ops-conftun-setup-00.txt

Comments, etc. are welcome, of course.

(note, section 5.5.1 should have been 5.6 but no matter..)

-- 
Pekka Savola                 "You each name yourselves king, yet the
Netcore Oy                    kingdom bleeds."
Systems. Networks. Security. -- George R.R. Martin: A Clash of Kings