Re: GMPLS MIBs

["Adrian Farrel" <adrian@olddog.co.uk>]

Thanks Len,

Much appreciated.

Adrian
----- Original Message ----- 
From: "Len Nieman" <lwnieman@bellsouth.net>
To: "Adrian Farrel" <adrian@olddog.co.uk>
Cc: <ccamp@ops.ietf.org>; "Tim Hall" <TimHall@dataconnection.com>; "Thomas D. Nadeau"
<tnadeau@cisco.com>; "Cheenu Srinivasan" <cheenu@alumni.princeton.edu>; "Edward Harrison"
<ed.harrison@dataconnection.com>
Sent: Friday, September 05, 2003 2:07 AM
Subject: Re: GMPLS MIBs


>
> >All I have just posted an update to the GMPLS MIB modules.
> >The model followed is to extend the MPLS MIB modules.
> >
> >At the moment the drafts are VERY rough, but we wanted to publish
> >them so that the WG can see the direction we are taking and
> >comment accordingly. In particular:
> >
> >- no attempt at compilation has yet been made
>
> I ran compiles on the drafts listed using the MG-SOFT MIB
> Compiler (MS Windows Edition) Version 5.0 RC1, Build 110.
>
> Prior to attempting this I compiled the appropriate MPLS MIB
> modules from the most recent mpls drafts. It wasn't included in
> your list, but I also compiled the LMP-MIB module from
> draft-ietf-ccamp-lmp-mib-06.txt while I was at it.
>
> The results were:
>
> draft-ietf-ccamp-gmpls-tc-mib-01.txt
>
> - GMPLS-TC-MIB module: Compiled okay after substituting the ifType
> value of "166" for the "xxx" here:
>
>    gmplsStdMIB OBJECT IDENTIFIER
>      -- This object identifier needs to be assigned by IANA.
>      -- Since mpls has been assigned an ifType of 166 we recommend
>      -- that this OID be 166 as well, i.e.
>    -- ::= { transmission XXX }
>    ::= { transmission 166 }
>
> ========================================
>
> draft-ietf-ccamp-gmpls-lsr-mib-01.txt
>
> - GMPLS-LABEL-STD-MIB module: Compiled okay after adding a second
> dash in front of the "The MPLS LSR MIB" comment here:
>
>      MODULE MPLS-LSR-STD-MIB - The MPLS LSR MIB
>
> - GMPLS-LSR-STD-MIB module: Compiled okay after correcting three
> instances of "SYNTAX Uunsigned32" to "SYNTAX Unsigned32" at these
> locations:
>
>    gmplsLabelWavebandId OBJECT-TYPE
>      SYNTAX        Uunsigned32
>
>    gmplsLabelWavebandStart OBJECT-TYPE
>      SYNTAX        Uunsigned32
>
>    gmplsLabelWavebandEnd OBJECT-TYPE
>      SYNTAX        Uunsigned32
>
> ===========================================
>
> draft-ietf-ccamp-gmpls-te-mib-01.txt
>
> - GMPLS-TE-MIB module:
>
> Error "Item 'MplsTunnelARHopEntry' is not defined or imported"
> at:
>
>    gmplsTunnelARHopEntry  OBJECT-TYPE
>      SYNTAX  MplsTunnelARHopEntry
>
> Error "Item 'DisplayString' is not defined or imported at:
>
>    GmplsTunnelErrorEntry ::= SEQUENCE {
>      gmplsTunnelErrorHelpString         DisplayString
>
> Error "Missing 'ACCESS or MAX-ACCESS" being created by an extraneous
> comma at the end of the SYNTAX line at:
>
>    gmplsTunnelErrorReporterIpv6Addr OBJECT-TYPE
>      SYNTAX  InetAddressIPv6,
>      MAX-ACCESS read-only
>
> ===============================================
>
> draft-ietf-ccamp-lmp-mib-06.txt
>
> - LMP-MIB module: Compiled okay after substituting the
> experimental value of "113" for the "xxx" here:
>
>    DESCRIPTION
>        "Initial version published as RFC xxxx (to be assigned by RFC
>         Editor)"
>    ::= { mib-2 xxx } -- To be assigned by IANA (experimental 113 can
>                      -- be used in the interim)
>
> =================================================
>
> Len Nieman
>
>